The laser will be able to tell the difference between the tag itself and the gap in between the tags.įor poly-faced tags, where the inlay of the tags can be seen, the laser will need to line up with the widest part of the inlay. Examplesįor paper faced tags, the laser can typically be placed anywhere on the left side of the tag. This will differ from tag to tag, but here are some examples. Typically, the laser will need to be positioned so that it lines up with the part of the tag’s inlay that has the widest surface area. Once this is done, the tags can be fed on through to the printer head.īefore we close the print head and perform a printer calibration, we will need to position the calibration laser. The yellow guide here is used to keep the tags from sliding, and the laser beneath the tags is used for calibration. ![]() The tags will then feed underneath the shelf here, and will need to be fed into this gap here. The tag reel sits on the rod in the far back of the printer, and this piece needs to be moved so that it sits tight against the reel. Now we will setup our tags to feed through the printer. Simply tape the ribbon to the ribbon roller and roll it back a few times to make the ribbon sit tight against the print head. The installation of the printer ribbon differs from printer to printer, but for the ZT410 printer, the ribbon will spool from its position here, underneath the printer head, and up to the ribbon roller. Next, we will install the printer ribbon. The ZT410 has a power switch on the back of the printer.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |